urmet domus 1083/19, Быстрый старт

Страница: 8 / 12

8
−−−−
sec.3h
2 VOICE - Technical Manual
CALL MODULE
When communication between the module and the switchboard
or directly with the apartment station called by the switchboard is
restored, the display shows:
SPEAK
PLEASE
TRANSMISSION OF SPECIAL CODES
If the system comprises special decoders, the call module can send
commands to activate load driving outputs (lights, gates, etc.)
When the call module is on stand-by, pressing the 0 key, the display
shows
CODE:
0
Continuing to press the 0 key for 2s, the call module switches to
special code mode and the display shows:
SPECIAL CODE:
0
Enter the 3-digit code (from 1 to 255) programmed in the special
decoder to be activated. The display shows this code with *:
SPECIAL CODE:
0***
Press X to delete the data entered; on completion of data entry, press
to sent the code. The display returns to stand-by status.
LOCK MANAGEMENT
The call module has 3 outputs for driving locks:
SE+, SE-
→
Direct driving for the main entrance electric lock with
capacitance discharge and holding current
C,NC,NO
→
Changeover driven in parallel with SE+, SE- with
contacts suitable for direct connection of externally-
powered electric locks
SE2, SE2
→
Output for vehicle entrance electric lock external
control NOT suitable for direct driving (normally used
to activate the electric gate control unit).
A button for driving main entrances can be connected to the PA,CT
terminals.
ENTRY OF DOOR-OPENER CODES
If door-opener codes (unrestricted or associated with names in the
repertory) have been programmed on the call module, the door
(pedestrian or vehicle) can be opened entering this code. The main
entrance lock is activated for codes from 0001 to 4999; the vehicle
entrance lock is activated for codes from 5000 to 5999.
When the call module is on stand-by, pressing the key , the
display shows
CODICE APERTURA
PORTA:
Enter the 4-digit door-opener code programmed. The display shows
this code with *:
DOOR LOCK
RELEASE CODE: ****
Press X to delete the data if you make a mistake; after entry, press
.
The display returns to stand-by status.
If the code is amongst those programmed, the lock is activated and
the display shows:
COME IN
PLEASE
If the code is not amongst those programmed, the lock is not activated
and the display shows:
WRONG
CODE
“POSTMAN” FUNCTION
If time bands have been programmed on the call module and the
function is active, the main entrance can be opened on the days and
at the times established simply by pressing the key.
After pressing this key, any door-opener code can be entered to open
the vehicle entrance.
PROGRAMMING VIA BLUETOOTH
The call module is equipped with a Bluetooth receiver-transmitter
to facilitate programming of con fi guration, names and door-opener
codes.
Enter the password to access programming, activate the 2Voice_
Mobile software (which can be downloaded from the Urmet site)
previously installed on the PDA or on the telephone and, from the
telephone, make the connection between the software of the
telephone and the call module.
The display shows:
BLUETOOTH
CONNECTED
Set as indicated in the user manual of the 2Voice_Mobile software.
To exit Bluetooth programming, press X for 2 seconds.
DIGITAL CALL MODULE Ref.1083/19 (2 Modules)
CALLS TO USERS
Ref. 1083/19
DIGITAL CALL MODULE