DS1058-007A
27
4.3.4 Configuration
IR detector does not need any configuration. The use of jumper JP1 is reserved.
4.4
OUTDOOR SIREN 1058/405
4.4.1 Power
supply
The device is provided with pre-installed batteries.
Loosen the screw at siren base and take off its covering.
Set power supply to ON to supply the siren.
4.4.2 Acquisition
Warning:
before acquiring the sirens, at least one more device has to be acquired.
Warning:
devices cannot be acquired if radio module 1058/010 is armed.
To make radio module 1058/010 acquire one or more sirens:
1.
Set radio module 1058/010 to acquisition mode as follows:
a.
Set both DIP switches A1 and A2 to ON.
b. Press
twice control pushbutton on radio module 1058/010. Radio module sends out 3 beeps and
LED
goes on steady, indicating that you entered actuation devices acquisition mode.
c.
Keep pressed for 3 seconds control pushbutton on radio module 1058/010. Radio module sends
out 3 beeps and LED
blinks once to indicate that actuation devices can be acquired.
2.
Set DIP switch 1 of sirens to ON to enable learning mode. The sirens can be acquired all together.
3. Press control pushbutton on radio module 1058/010 to send the code. the code is received, the siren
sends out 1 beep (in siren 1058/405 LEDs 1 and 3 blink too). Then radio module sends out 2 beeps
and zone LEDs flash, indicating that the sirens were acquired. If radio module sends out one beep
only, it means that the siren had already been acquired. Should radio module not send out any beeps,
repeat point 3.
4.
Set both DIP switches 1 and 2 of radio module 1058/010 MR16 to OFF to quit acquisition mode (radio
module 1058/010 sends out one two-tone beep). Radio module 1058/010 automatically quits
acquisition mode if no operations are performed for 3 minutes.
