17
4.6 Set Error Limit
This function sets the error tolerance range while checking the flash. Use the
▲▼
buttons
to set the error limit value. Select units to use (KB or MB), then select the value.
4.7 Minimum Read Speed
This function can be used to select the flash media whose reading speed is too slow. Users
can set an expected minimum reading speed for media check, so the flash media that
doesn’t reach the minimum speed value will be identified.
4.8 Minimum Write Speed
This function can be used to select the flash media whose writing speed is too slow. Users
can set an expected minimum writing speed for media check, so the flash media that
doesn’t reach the minimum speed value will be identified.
Note
When the red-light illuminates to indicate that an error has occurred, use
the
▲▼
buttons to view the error information.
4.9 Low Speed Tolerance Time
Sets the tolerance time when flash does not reach the minimum speed from 10~99
seconds. The default value is 20 seconds.
4.10 Set Capacity Limit
This function is used to set the flash device testing capacity limit. Users can set an upper
and lower limit of the flash capacity. To reset, select “clear limit”.
[Setup Unit]
MB
[Setup Error Limit]
9000MB
[Minimum Read Speed]
10.0MB/Second
[Minimum Write Speed]
10.0MB/Second