Page 11
MX-HomePro MXHP-H500 (Hub)
Network Installation
The hub can be installed using Wi-Fi or an Ethernet connection, keep in mind the initial
programming must be performed with a wired connection.
When being installed for the first time, one of the two following steps must be followed:
Wired Ethernet
Connect the hub to the router using the supplied Ethernet cable. See image below for proper
Ethernet placement.
OR
Wireless (Wi-Fi)
1. Connect the hub to your wireless access point by using the WPS button (page 10) and
pressing the button on the wireless access point/router.
2. If successfully connected, the Wi-Fi LED glows blue, green, yellow, or red based on the
signal strength (
page 8
).
Setup is now complete, if you wish to set specific network setting see the following section.
When the Status LED illuminates red, use the MXHP-R500 remote to set the network proprieties of
the hub (see MX-HomePro Installation Guide).
To set the network properties of the hub, insert the battery into the remote and follow the on-
screen prompts (for more details refer to the MX-HomePro Installation Guide).
The MXHP-R500 remote is required to be on the same
network as the hub in order to set its network properties.
