11
System settings
To enter the settings for your product, press the "+" and "-" buttons on your screen for 5 seconds.
Attention!
If you change all the basic settings, you change the performance and condition of your product. We
recommend that you only change the settings below:
Menu
Setting
P01
Brightness adjustment
P02
Adjusting the unit of measurement of the distance
0 = KM 1=MILES
P04
Screen saver time
0 = No sleep mode 1 to 60 = The number of minutes of standby time
P09
Start-up mode
0 = Immediate start 1 = Impulse to start
Error code
ERROR
PROBLEM
E06
Battery
Check that your battery is fully charged. If so, check that the battery compartment (Tray) is not damaged.
Then check the condition of your product's cables.
E07
Motor
Check the condition of the cables in your product. Then check the condition of the motor(s).
E08
Accelerator
Check that the throttle trigger is in good condition. Check the condition of your product's cables.
E09
Motherboard
Check the condition of the cables in your product. Changed the motherboard.
E10
Reception cable
Signal lost, check the condition of the cables in your product. This problem may be caused by the
motherboard or the display.
E11
Transmission cable
Signal lost, check the condition of the cables in your product. This problem may be caused by the screen.
E30
Communication error
Go to the settings of your product by pressing and holding down the "+" and "-" buttons. Go to setting
P20 and enter 0.
