1
4.
3
Igniting the pilot light
Check that the control knob (A) is in the ON position.
(1)
Press the On/Off button of
your remote control and
continue to hold down (3 to 5
sec
onds
) until you hear two
short beeps.
(2)
The ignition sign will appear at the top of the screen:
(3)
Now release the On/Off button. The ignition procedure has
been started.
NB: If the pilot light doesn’t remain lit after 3 attempts you must
turn off the gas tap and warn your installer.
A few seconds after starting the pilot, the main burner will start to
light. (Safety system - always wait 2 minutes after killing the pilot
light before you start the pilot flame again).
(4)
Adjustment of flame height.
The flame height can be adjusted by use of the Up/Down
buttons. Allow a couple of seconds for the motorised valve to
adjust the gas flow.
(5)
Switching off the fireplace.
Switch off the fireplace by pressing the On/Off button, this also
turns off the pilot light
Urban Fires UF950RCS Installation & Use Instructions V3.10 Nov 2019 Page
1
5
