1"
Important:
After installation and tightening the seat belt
anchorage point and buckle must be at least
1 inch from the main lap belt guides slot and
towards the FOOTREST END of the child seat.
If it is closer or toward the rear the child seat
cannot be safely fitted using this belt route.
If in doubt, refer to the manufacturer or retailer
for advice.
5
Step 4
Ensure the seat belt is not twisted. Then, lean on
or press down on the handle to push the child
seat down into the vehicle seat (1), while pulling
on the lap and diagonal sections (2) and (3) of
the seat belt to remove any slack.
Once the seat is secure, it is ready to use.
Do a final security check as shown in section 12
‘Checking the security of the seat’.
4
2
1
3
fitting the child seat with standard seat belts
11
Car Seat V6 D4 ML 7/4/05 12:05 PM Page 13
