Package Contents
Warnings and Cautions
1of2
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
A
Inner Backplate
x 1
Please go to
for product cleaning tips. Go to the
selection.
(1) A19 Medium Base Bulb 100W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.
20-30 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.
www.quoizel.com
Care + Maintenance
Light Source:
Estimated Assembly Time:
Preparation:
Fixture can only be mounted in the direction indicated on page 2.
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Fixture Body
x 1
C
B
Lock Screw
x 2
STEP 2
Reverse backplate if necessary
-
A. Remove small hex nuts and small lock washers from the back of the
backplate.
B. Loosen the hex nut with lock washer and do not remove them.
C. Push the backplate as the arrow until the backplate and the bracket
are separated. Reverse the backplate.
D. Place the backplate back onto bolts on the bracket and secure with
Small Hex Nut
Small Lock Washer
Hex Nut with
Lock Washer
Bracket
Bolt
Backplate
Figure 2
Backplate
Backplate
PUSH
REVERSE
TOP VIEW
FRONT VIEW
(Step 2 Continued)
previously removed small lock washers and small hex nuts. Hand
tighten until snug.
E. Tighten the hex nut with lock washer and hand tighten until snug.
STEP 1
Remove Papers Inside of the Cage
-
A. Rotate the bolt and remove it from the bolt holder to open the door.
B. Remove papers inside of the cage.
C. Close the door and place the bolt back onto the bolt holder.
Figure 1
Door
Bolt
Bolt Holder
Paper
(Remove)
Outlet Box
Supply Wires
with Ground Wire
Outlet Box Screws
(not included)
A
Mounting Hole
STEP 3
Installing the Inner Backplate
-
A. Pass the supply wires through the Inner Backplate (A). Attach the
Inner Backplate (A) to the outlet box with two mounting holes on the
side. Secure the Inner Backplate (A) with outlet box screws (not
included). Tighten until snug
.
Figure 3
Installation Instructions:
UQL1
4
1
3
www.urbanambiance.com
