UP-308FEW / UP-316FEW
Forward Delay:
The maximum time (in seconds) the root device will wait before changing
from its Rapid Spanning Tree Protocol learning and listening states to the forwarding state.
Enter a value between 4 through 30 (the default is 15).
Click
Submit
for the configuration to take effect.
The
Bridge Status
table shows the STP configuration of the switch. The
Root Status
table
shows the Root Switch’s Information of the STP domain.
STP Port Settings
This page allows to set the STP port priority and its path cost.
After STP/RSTP is enabled, the priority and path cost are automatically assigned to the port.
Normally, it is necessary to change the parameters, however, you may need to control the
root switch or block port in some condition.
Select the
port number
, enter the values of the
Priority
and
Root Path Cost
and click
Submit
to apply the settings.
User Manual 38
