Upright AB46RT, Руководство оператора

Страница: 10 / 48

10
HYDRAULIC OIL
1. Check oil level at sight gauge inside engine compart-
ment right hand side with the platform fully lowered.
2. If necessary, fill to capacity with clean ISO 46
compatible hydraulic oil.
3. Lift flap located on top of chassis right side (see
figure 9).
4. Open filler / breather cap to add hydraulic oil.
5. Replace cap.
LUBRICATION
Refer to service manual for lubrication chart and
guidelines.
BATTERY MAINTENANCE
Hazard of explosive gas mixture. Keep sparks,
flame and smoking materials away from
batteries.
Always wear safety glasses when working with
batteries.
Battery fluid is highly corrosive. Rinse away any
spilled fluid thoroughly with clean water.
Always replace batteries with UpRight batteries
or manufacturer approved replacements
weighing 62 lbs. (28 kg) each.
Check battery fluid level daily, especially if work platform
is being used in a warm, dry climate.
If electrolyte level is lower than 3/8 in. (10 mm) above
plates add distilled water only. DO NOT use tap water it
will shorten battery life.
Keep terminals and top of battery clean.
TIRES
Tire selection can affect the stability of the machine.
Use only tires supplied by UpRight unless approved by
the manufacturer in writing.
Figure 9: Hydraulic Oil Filler / Breather Cap
Hydraulic Oil Filler / Breather Cap
Maintenance
FUELING
Gasoline
1. Open fill pipe cap located on chassis left side (see
figure 8).
2. Fill to capacity with unleaded motor fuel only.
3. Check fuel level by lifting flap located on top of
chassis left side (see figure 8). Fuel tank full capacity
is 25 US gallons.
Diesel
1. Open fill pipe cap located on chassis left side (see
figure 8).
2. Fill to capacity with diesel motor fuel only, grade #1-D,
or #2-D. Use distillate fuel only, do not use residual or
blend.
3. Check fuel level by lifting flap located on top of
chassis left side (see figure 8). Fuel tank full capacity
is 25 US gallons.
Figure 8: Fuel Fill Pipe and Level Gauge
Fuel Level Gauge
Fuel Fill Pipe