Climate Control Zoning System II instruction sheet l 9
Register thermostat and/or
system device to a controller
Enter registration mode
1. Press and hold the
OK
button on the controller for about 3
seconds until the LED for channel 1 (or the first unregistered
channel) flashes red.
2. To register a thermostat, select a thermostat channel.
a. Use buttons
<
or
>
to move the pointer (LED flashes red)
to a preferred channel.
b. Press the
OK
button to select the channel for registration.
The LED for the selected channel starts flashing green.
c. Repeat steps 2a and 2b until all channels to be registered
with the thermostat are selected (LEDs flashing green).
Note:
Uponor recommends registerating all channels to the
thermostat at the same time.
3. Select a thermostat.
a. For the Wireless Digital Thermostat (A3800167),
press and hold both - and + buttons on the
thermostat until the text
CnF
(configure) and a
communication icon displays. The selected channel
LED in the controller turns fixed green and the
registration is complete.
b. For the Wireless Dial Thermostat (A3800165),
gently press and hold the registration button on
the thermostat for about 5 seconds. Release
when the LED on the front of the thermostat starts
flashing. The selected channel LED in the controller
turns fixed green and the registration is complete.
4. Repeat steps 2 and 3 until all available thermostats
are registered.
Exit registration mode
5. Press and hold the
OK
button on the controller for about
3 seconds until the green LEDs turn off. This will end
registration mode and return the system to run mode.
Unregister one channel
When a channel is inaccurately registered, or if a thermostat
registration needs to be redone, it is possible to remove the
current registration from the controller.
To unregister a channel:
1. Enter registration mode. Channel 1 LED flashes red/green, or
the first unregistered channel flashes red.
2. Use buttons
<
or
>
to move the pointer (LED flashes red)
to the selected channel (flashes green if registered) to
unregister.
3. Press the
<
and
>
buttons simultaneously for about 5 seconds
until the LED for the selected channel starts flashing red.
Unregister all channels
When one or more channels (thermostats) are inaccurately
registered, it is possible to remove all registrations at the
same time.
To cancel all channel registrations:
1. Enter registration mode. Channel 1 LED flashes red/green or
the first unregistered channel flashes red.
2. Press the
<
and
>
buttons simultaneously for about 10
seconds until the LEDs for all channels (except one) turn off.
The remaining LED flashes red.
Actuator autobalancing
Refer to the Climate Control Zoning System II installation and
operation manual for more information about autobalancing
of actuators (eliminating the need for manual balancing, on by
default), heat pump integration, cooling, comfort/ECO settings,
room check, supply check, etc.