4 of 6
SYNCHRONIZE
Automatic Learn Function:
1. After inserting the batteries, the indoor temperature is displayed.The base station now tries to pick up signals
from sensors for 3 minutes.If no signal is detected, bars are shown on the display.
2. As soon as the base station has detected a sensor signal, the display then shows the temperature value
received from the sensor.
3. If reception is lost before the time can be set, then place the base station, which has better reception, such as,
near a window. Please re-do the above procedure to restart the search for signals from sensors.
*If the signals are not received within this 3 minutes, the outside temperature will show ”- - -“ , during this time, bringing the unit close
together or try different location and restart the auto learning function by removing and replacing the batteries for receiver.
Manual-Learn function (Searching for Remote Signals):
If a new transmitter is added or if signal is lost (outdoor display blinking), learn function must be executed again.
1. Press the “Channel” button and hold for 3 seconds. The Outdoor symbol starts to flash and the base station
confirms your setting by sounding an audible tone.
2. As soon as the base station has detected a sensor signal, the base station display then shows the temperature
value received from the sensor.
3. It is recommended to place the transmitter and receiver together during synchronization process. If the green
indicator of transmitter flashes and the data is shown onto the receiver, this process is considered to be
successful; otherwise, it is recommended to repeat this process.
CLOCK/DATE SETTING
Clock / Date / Month / Year Setting:
1. Hold
“
Mode
” key to go into Clock Setting Mode;
2. Press
“
MAX / +
” key to increase hour digit and “
MIN / -
” key to increase min digit;
3. Press
“
Mode
” key to go into Date Setting Mode;
4. Press
“
MAX / +
” key to increase Date digit and “
MIN / -
” key to increase Month digit;
5. Press
“
Mode
” key to go into Year Setting Mode;
6. Press
“
MAX / +
” key to increment and “
MIN / -
” key to decrease Year digit;
7. Press
“
Mode
” key to cease the setting and back to clock display
8. Press
“
Mode
” at clock display mode to change between 12/24 hr display
