3 of 6
GETTING STARTED
Warning: Any changes or modifications made to this equipment not expressly approved by
Mandolyn Electronic Ltd. may void the FCC authorization to operate this equipment.
USING THE THERMOMETER FOR THE FIRST TIME
!
Set up the transmitter for use first so that the base station can receive a signal immediately.
Step 1: Using the transmitter for the first time
1. Open the battery compartment of the transmitter.
2. Insert
2xAA
batteries included with purchase. Ensure correct po/- as shown in the compartment.
Replace the cover.
3. Once the batteries are inserted correctly, the display will show “01H” for House Code, and the range of House
Code is from “01” to “15”, change the House Code by pressing C/F key and SET key to confirm. Make sure all
transmitters in your system are set to the same House Code.
Note: It is highly recommended to change to different House Code if interference is experienced.
4. After the House Code is set, it goes to Channel setting, and there is a number 1 is flashing at the left-hand side
of LCD. Same as House Code setting, pressing C/F key to change the Channel and SET key to confirm. After this,
it will go to Temp unit setting.
Note: if there are more than 1 transmitters need to be connect to same receiver, then the House Code of all the
transmitter should be the same but the Channel number is different.
5. The temp display will be flashing after the Channel, and pressing C/F to toggle between C and F display. Then, it
can leave it and the transmitter will transmit the 1
st
signal automatically. If pressing SET key, then will go back to the
house code setting again.
6. Once setup of remote transmitter is completed, it will start transmission in one minute interval.
*The setting is confirmed automatically if it is in idle for 8 seconds.
*Use different house code if your weather station detected other signals from neighboring sources
*Factory default: house code=01 and channel=
01
Step 2: Setting the base station
1. Remove battery cover and insert
2xAA
size batteries, ensure correct po / - as shown in the compartment,
replace the cover.
