6
4.DMX Channels
10 Channel mode
Channel
Name
DMX Value
Description
1
Pan
0-255
Pan Movement
2
Pan Fine
0-255
Pan Fine
3
Tilt
0-255
Tilt Movement
4
Tilt Fine
0-255
Tilt Fine
5
P/T SPEED
0-255
P/T SPEED
6
ZOOM
0-255
ZOOM
7
CTO
0-255
Change Color temperature (2600-6500K)
8
Dimmer
0-255
Dimmer from dark to bright
9
STROBE
0-5
OPEN
6-10
CLOSED
252-255
STROBE FORM SLOW TO FAST
10
RESET
250-255
Reset after 3 seconds
5.Trouble Shooting
Following are a few common problems that may occur during operation. Here are some suggestions for
easy troubleshooting:
A. The unit does not work, no light and the fan does not work
1. Check the connection of power and main fuse.
2. Measure the mains voltage on the main connector.
3. Check the power on LED.
B. Not responding to DMX controller
1. DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
2. If the DMX LED is on and no response to the channel, check the address settings and DMX
polarity.
3. If you have intermittent DMX signal problems, check the pins on connectors or on
PCB of the unit or the previous one.
4. Try to use another DMX controller.
5. Check if the DMX cables run near or run alongside to high voltage cables that may cause damage or
interference to DMX interface circuit.
C. One of the channels is not working well
1. The stepper motor might be damaged or the cable connected to the PCB is broken.
2. The motor
’s drive IC on the PCB might be out of condition
