®
4530
7
WARNING
The body of the car or any other metal structure can affect the accuracy of the GPS
signals and prevent normal operation. Location of the GPS unit is critical to the
operation.
Installation Safety & Warnings:
• Do not install the unit where it may hinder the function of safety devices such
as an air-bag. Doing so may prevent the air-bag from functioning properly in the
event of an accident.
• The installation and use suggestions contained in this manual are subject to any
restrictions or limitations that may be imposed by applicable law- purchaser
should check applicable law for any restrictions or limitations before installing
and/ or operating this product.
• Failure to follow these safety instructions and warnings may result in personal
injury or death.
12-VDC Power Connection (Red Wire)
Locate the Red wire found on the connector supplied with the UplinkGPS autoPRO
unit. The red wire must be connected to a constant 12 volt source from the vehicle
to power the UplinkGPS autoPRO unit. It’s important that the 12 volt power source
maintains 12 volts at all times.
Ground Connection (Black Wire)
Locate the Black wire found on the connector supplied with the UplinkGPS autoPRO
unit. The black wire must be connected to a solid chassis ground uninhibited by
paint or plastics. It is important that you do not use any floating grounds from the
vehicles electrical system. Always connect the ground directly to the chassis body
and secure with a factory bolt or aftermarket screw.
Switched 12 Volt Connection (White Wire)
Locate the white wire found on the connector supplied with the UplinkGPS auto-
PRO unit. The white wire must be connected to a switched 12 volt source from the
vehicle. This connection is used to monitor the engines on/off state. It’s important
that the switched 12 volt source drops to (0) zero with the ignition off and restores the
switched 12 volts with ignition on.
®
auto
PRO
GPS
auto
pro
®
