4
UPLIFT Desk 1-800-349-3839
5.
ASSEMBLY INSTRUCTIONS
A.
First, Lay out all components and hardware to ensure that you have all the parts listed on the compo-
nents list. Then Slide Crossbar Center Rails (Part #4) out of Crossbar Ends (Part #3).
Turn Legs (Part #1) and Crossbar Ends (Part #3) on their
sides. Make sure Crossbar Ends (Part #3) have the
labeled “Top Arrow” pointing towards where the desktop
will be. Since you have the parts on their side at this
point, the arrow should be pointing away.
Line up the holes on each Leg (Part #1)
with the holes on each Crossbar End (Part #3).
B.
IMPORTANT! DO NOT TIGHTEN SCREWS IN THIS STEP, ONLY INSERT THEM
AND ROTATE 3 TIMES. YOU WILL TIGHTEN IN STEP D.
Insert qty 4 Machine Screws (Part #11) through the 4 holes of each Crossbar End (Part #3)
going into the Leg (Part #1). Using the Allen Wrench, rotate each screw ONLY 3 times.
C. IMPORTANT! DO NOT TIGHTEN SCREWS IN THIS STEP, ONLY INSERT THEM
AND ROTATE 3 TIMES. YOU WILL TIGHTEN IN STEP D.
Line up the 4 holes on the Side Brackets (Part #5) with
the Crossbar End and Leg assembly from the previous step.
Insert qty 4 Machine Screws (Part #11) through
the 4 holes of the Side Bracket (Part #5) going into
the Crossbar End/Leg Assembly. Using the
Allen Wrench, rotate each screw ONLY 3 times.
Remove backing from adhesive pads
and position along the bracket as shown.
This will end up being
the top side of the desk.
1
4
4
11
11
3
3
3
11
5
3
If you are having trouble getting all the screws
started, it is because other screws are too tight.
You’ll need to back out some screws in order
to loosen the tolerance of the screw holes.
!
Do not tighten machine screws
yet, only rotate each 3 times.
!
If you drop a screw inside the Crossbar
End, simply tilt to retrieve the screw.
!
