5
© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
Step 5
Determine which holes to use.
This frame is designed to attach to UPLIFT desktops
from 48’’ to 80’’ wide and 24’’
or
30’’ deep. Refer to
the arrows in Fig A. for proper screw placement on
30’’ deep desktops and Fig. B for 24’’ deep desktops.
For 30’’ deep desktops, first align the center slots of
the Leg assemblies with the three mounting holes
along each side of the desktop. Once the desktop
holes are aligned with the Leg assembly slots, you will
notice that one of the eight slots in each Crossbar end
will be closely aligned with a mounting hole toward
the middle of the desktop.
For 24’’-deep desktops, align the three mounting
holes along each side of the desktop with the outer
slots in the Leg assemblies, which allows the assembly
to be centered on the desktop. If the frame assembly
hangs off the front or back of the desktop, use the
outer slots on the opposite sides of the center slots.
Fig. A. 30’’ desktops
Fig. B. 24’’ desktops
Step 6
Determine which type of screw to use.
If your pre-drilled desktop does not have metal
threaded inserts, use the #10x3/4’’ Screws (H2a).
If your pre-drilled desktop does have metal threaded
inserts, use the #10-24x3/4’’ Screws (H2b).
After ensuring that the table frame is properly positioned,
attach the frame to the desktop using eight of the cho-
sen screws (H2a or H2b) and eight Washers (H3).
Make sure all screws are started before tightening
completely. Be careful not to over-tighten to avoid
stripping.
If you have purchased casters for your side table, in-
stall them now. Unscrew the leveling glides already in
the legs, and screw in the casters in their place.
or
H2 b
H2 a
C3
C4
C5
C9
H4a
H7
C6
H1
H2
H3
H5
H4b
H6
C7
C3
C4
C5
C9
H4a
H7
C6
H1
H2
H3
H5
H4b
H6
C7
C3
C4
C5
C9
H4a
H7
C6
H1
H2
H3
H5
H4b
H6
C7
C3
C4
C5
C9
H4a
H7
C6
H1
H2
H3
H5
H4b
H6
C7
H3
Step 7
Slide in each Crossbar rail (C3) until the Center indica-
tor mark is in the middle. Once this is done, the Cross-
bar rail will be centered and in the proper position.
Insert the eight remaining M8x8 Set screws (H1) into
the Crossbar ends (four on each side) to secure each
Crossbar rail, then tighten using the Allen wrench (H4).
