© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
2
Step 2.2 - Clamp Base
Use the 4mm Allen Wrench to adjust the four pre-in-
stalled screws on the back of the Lower Clamp so that
there are about 0.25” of thread between the plate and
screw heads.
There are two sets of key slot holes to choose from for
different desktop thicknesses.
For Desks 0.4’’ to 2.25’’ use the top four holes (fig. 1)
For Desks 2’’ to 3.3’’ use the bottom four holes (fig. 2)
Insert the four screws of the Lower Clamp through
four of the key slot holes in the back of the Upper
Clamp as shown.
Slide the Lower Clamp assembly down so that the
screws are at the bottom of the key slot holes then
tighten screws with 4mm Allen Wrench.
fig. 2
fig. 1
6mm
6mm
6mm
6mm
Step 2.3 - Clamp Base
Using the 6mm Allen Wrench, adjust both bolts on
the bottom of the Lower Clamp so that the opening
is wide enough to accommodate the thickness of the
desktop and Lower Base Plate.
Place the outer holes of the Lower Base Plate onto the
tips of the bolts as shown.
Slide the assembly onto the back of the desktop, then
tighten the bolts using the 6mm Allen Wrench. Alter-
nate from one bolt to the other, to allow the Lower
Base Plate to rise evenly before finally tightening to
the desktop.
Optional “Bolt-Through Base” Assembly
Only complete steps 2.4 to 2.7 if you are not going to clamp the monitor arm to the desktop.
Optional Step 2.4 - Bolt-Through Base
Ensure the desktop has a hole between 0.4’’ and 3.1’’
in diameter to use this option. Using a grommet hole
that is already in your desktop is acceptable, or you
can drill a 0.5” hole anywhere on your desktop.
Optional Step 2.5 - Bolt-Through Base
Align the Upper Base Plate with the Base in the orien-
tation shown and attach it using the four M6x12 Flat-
head Screws and the 4mm Allen Wrench.
Then peel the adhesive backing off of the Adhesive
Pad and attach it to the bottom of the Base and Up-
per Base Plate as shown. Align the pad with the front
edge of the Base first, then work to the back.
0.4”
3.1”
