© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
8
R.
Take four (4) #10x5/8’’ Wood screws
(Part 17a). Screw two (2) wood screws into
each Support bracket (part 8).
Use one (1) of the screws used in Step J, page 6,
into the remaining hole in the Corner crossbar end.
S.
Insert and tighten the remaining M6x10
screws (part 16) into the remaining Crossbar
ends, to secure the rails in place.
T.
Connect the Legs and Keypad to the Control box with
the Cables (part 13). You will find that they all hang loose.
Once everything is connected, use the Cable clips (part 19)
to keep them snug up against the desktop, to prevent them
from getting caught on things under your desk.
Note:
Depending on your desktop type and its texture,
the Cable clips may adhere better to the frame.
16
13
19
V.
Plug the Power cable into a 120v outlet.
IMPORTANT! You must RESET the desk prior to use!
Press and hold the DOWN button on the Keypad until the desk reaches its
lowest height, then release the button. Press and hold the DOWN button again
until the desk lowers a little bit more, slightly rises, then stops. Release the button.
Your desk has been reset, and is now ready to use.
If you have the Advanced 1-touch digtal keypad, the digital display will flash
“RST” when you press the DOWN button a second time. For more programming
options with the Advanced 1-touch digital keypad, refer to the “Programming”
section on page 14.
17 a
*
*
