6.
Telecontrol
CommPact User Manual
21
Do not enter your user code until you hear the two tones. Any digits entered
before the tones are sounded are disregarded by the system.
3.
A tone is sounded to indicate that the system is ready to receive commands.
The following commands are available:
•
Press “
2
”
for Two-Way Audio.
If the TWA mode is defined as “Simplex” (see p. 22
6.5.
Simplex Mode.), the audio channel opens in Listen mode
(microphone active/speaker mute). To switch to Speak mode,
press “
1
” on your telephone. To switch back to Listen mode,
press “
0
” on your telephone.
During the TWA session, you can adjust the speaker
volume using the arrow buttons.
•
Press “
3
" to fully set the system.
•
Press
"430"
to activate PGM output (Unit 30)
•
Press
"530"
to deactivate PGM output (Unit 30)
•
Press “
6
” to unset the system.
•
Press “
9
” to cancel the sounder.
4.
The duration of the call is an option programmed by your engineer. Ten
seconds before the end of the call, two short tones are sounded. To extend
the call, press “
7
” on your telephone.
5.
To disconnect before the end of the call, press “
*
” then “
#
” on your
telephone.
Sounder Muting
The sounder is muted during Two-Way Audio communication. At the end of the call,
the sounder is re-activated (if the Sounder Cut-Off has not yet expired). You can cancel
the re-activation of the sounder by pressing “9” on your telephone during the call.
The Set/Unset, PGM on/off, and Sounder canceling can
also be executed at any time during a Two-Way Audio
session.
Error beeps (three tones) sound in case of a wrong
command.
To clear the last command, press “*” or “#”.
