23
A note about pre-drilling:
Predrilling desktops can simplify the desktop installation process. It is not
recommended to pre-drill Melamine desktops. Screwing into predrilled desktops is certainly far
easier on Hardwood desktops such as Messmate, Vic Ash, Jarrah and Acacia. Whilst not necessarily,
some customers report pre-drilling of Bamboo desktops also useful.
To predrill holes, once the frame is perfectly centred per the steps above, using a pen/marker, place
a dot in the middle of each affixing point. Remove the frame in preparation for drilling. Using a
power drill and a 2.5mm drill bit, drill a hole between 10-12mm deep.
IMPORTANT
: Be extremely
careful not to drill further as you may run the risk of drilling all the way through the desktop!
The
frame can then be attached using the self-tapping screws either with a manual or electric
screwdriver
With the desktops square, install the joining bars using the supplied self tapping screws. Only 4
screws per bar are necessary. Ensure 2 screws per side are installed (8 total) as indicated below.
