UPair 2 Ultrasonic 3D+4K, Руководство пользователя

Страница: 13 / 28

Operations Detailed Steps
Start Press Recording once to start the recording process.
End Press Recording once to stop the recording process.
(6) Gimbal Pitch Control Roller: The position-type potentiometer control is applied, and the
impeller will be rotated to adjust the Gimbal's pitch angle.
(7) Contrast switching wheel:
Rotary camera control with rotary encoder control.
(8) Flight Mode 3-Gear Switch:
Adjust the switch to change the Flight Mode. Available Flight Modes include: 1. Altitude Hold 2.
Position Hold 3. Headless Mode
(9) Emergency Stop:
1. During normal flight, press down three buttons (RTH Button, POWER Button, and Take-off
Button) on the control panel simultaneously to trigger an Emergency Stop with corresponding
voice prompts (one long sound and two short sounds).
2. Canceling the Emergency Stop: After Emergency Stop is triggered, press down Photo and
Recording simultaneously to cancel Emergency Stop, and the voice prompt will disappear.
Charging The Remote Controller
Use only the original UPAIR charger. The charger has dual heads for charging the aircraft's
battery and the RC battery. Charge the RC battery by connecting the RC battery with the
charger using the corresponding plug.
The charger can be used to charge the aircraft's battery and the Remote Controller Battery at the same
time, but their charging times are different. It will take about 2.5 to 3 hours to fully charge the aircraft's
battery, and 1.5 to 2 hours for the Remote Controller battery. If you use it to charge the aircraft's battery
and the Remote Controller battery at the same time, the charging time will be longer.
Operating The Remote Controller
The default factory setting follows the American standards. This manual uses examples from
American best practices to explain how to operate an aircraft by using the controller:
Remote
Control (American
Standard)
Aircraft/Switch Altitude Hold/Position Hold/IOC Mode
12