PREPARING THE APPLIANCE FOR OPERATION
1. Comply with all safety instructions and safety regulations.
2. Ensure that you have selected a safe location.
3. Plug the mains plug of the appliance into an electrical outlet (220–240 V ~
50 Hz).
4. Select the desired function on the rotary function regulator:
Heating operation
- Level “I” for less heat
(approx. 1,300 watt)
- Level “II” for more head
(approx. 2,000 watt)
For heating operation select the desired temperature via the rotary thermo-
stat regulator, by turning the regulator. The regulator is variably adjustable.
The indicator light shows the mode.
Fan operation
Level “ “ for the fan function (cool air)
Attention: If the appliance was previously on heating operation, the outflow-
ing air will still be warm initially. Depending on the previous heating capac-
ity it can take some time until the appliance provides cool air.
When you adjust the fan function, you must place the rotary thermostat
regulator on the highest position.
5. The appliance heats until the desired temperature is reached, then the
appliance switches off. The appliance will switch on again as soon as the
room temperature drops below the set temperature.
6. To switch off the appliance, place the rotary regulator on position “O” and
unplug the mains plug.
Be aware that the appliance can become very hot - fire hazard! Particularly
ensure that children are kept away from the appliance.
OSCILLATION FUNCTION / SWING FUNCTION
1. With this function it is possible to distribute the air flow over
a larger area, because the appliance swings back and forth in a
specific radius.
2. The oscillation function can be switched on in every mode. To
do this, press the “I/O” button on the top of the appliance.
3. If you want to stop the appliance in a specific position, press the “I/O” but-
ton again.
4. Switch off the oscillation function before you switch off the appliance.
Copyright UNOLD AG | www.unold.de
