P a g e
| 21
ÜKYP/YP Automatic Fuel Loading, Central System Heating Boiler Usage and Maintenance Manual
TEMPERATURE SET will appear on the screen. You can press and hold the
buttons until you reach the temperature you want to set.
When it reaches the desired level, you can memorize it by pressing the
ENTER button.
Press the
Fan Setting button of the panel. A rectangle will appear
around the line in the upper left corner.
When you press the
button once, it increases the fan level once more and
as in the second figure,
As soon as you press the
ENTER button, the fan setting you have set will
be memorized and the image on the screen will be as in the third figure.
The fan speed will remain at Level 1 during ignition.
kazan kapasitesine ve yakıt tipine göre olması gereken ayarları bulunuz.
In the
"Fuel supply -
Feeding Settings" section of your
manual, find the settings that should be according to the boiler capacity and fuel
type.
Press the
Fuel Feed button to adjust the amount of fuel to be given
into the boiler. After setting the required feed setting from the buttons, press
the
ENTER button to memorize it. Press the
Fuel Standby
button for standby setting. After setting the required standby setting from the
buttons, press the
ENTER button to memorize it.
If it is desired to increase extra energy during combustion, the auger is fueled by pressing the
Manual
fuel feeding button. As long as this button is pressed, it supplies fuel, when the finger is pulled, it cuts off the
supply.
Pressing the
ON/OFF button will be sufficient to turn off the boiler. As long as the power is not
disconnected (power failure, unplugging the boiler), the pump will continue to run until the temperature
drops.
To light by hand feeding:
Large pieces of fuel to be burned in the boiler are placed inside the boiler.
Open the control panel by pressing
the button of the device for 2
second.
By pressing the
Wood Mode button, the boiler is fed manually.
In wood mode;
