6512
9.
Reinstall pulley insert and shims that may have been present. Apply liberal coating of Petro-Gel to
the seal/insert interface.
10.
Reinstall knife, knife guard and sharpener in the reverse procedure outlined above.
SHARPENING STONES
1.
Warning:
Disconnect electrical cord.
2.
Unscrew sharpener knob assembly (Figure 5 [28]).
3.
Lift up sharpening assembly (Figure 1 [2] ) and remove from slicer.
4.
Using an open end wrench, unscrew cover knob (Figure 5 [1] ). It is recommended that a piece of
tape or paper be temporarily wrapped around knob prior to unscrewing it so as to protect its finish.
Remove cover (Figure 5 [2]) off of mount assembly.
5.
Unscrew nut (Figure 5 [19] ) and remove along with washer and sharpening stone (Figure 5 [21]).
6.
Install new sharpening stone. Hollowed side should be toward the outside.
7.
Honing (deburring) stone (Figure 5 [12] ) is removed by first unscrewing lock screw (Figure 5 [17] )
from button (Figure 5 [16]).
8.
Gently remove button taking care to not lose the small ball bearing and spring (Figure 5 [14 & 15] )
which are inside.
9.
Unscrew nut (Figure 5 [13] ) and remove along with washer and honing stone (Figure 5 [12]).
10.
Install new honing stone with the hollowed side toward the inside.
11.
Reattach cover and reinstall in the reverse procedures (4. through 1.).
DRIVE BELT REPLACEMENT
1.
Warning: Disconnect electrical power cord.
2.
3.
Remove knife per knife replacement instructions. Remove the 7 screws (Figure 3 [14]) and belt
guard (Figure 3 [15]).
4.
Remove four rubber suction feet (Figure 6 [13] ) that secure bottom cover (Figure 6 [12]) to slicer.
Remove cover.
5.
Remove nuts (Figure 3 [21] ) from motor adjustment rod (Figure 3 [26] ) so motor can be pivoted to
give belt slack. Be careful not to lose tensioning spring (Figure 3 [19] ).
6.
Remove motor pivot bolt (Figure 3 [28]).
7.
Unwrap belt from motor pulley shaft.
8.
Unwrap and remove drive belt from the knife pulley (Figure 3 [6] ).
Page 11
