4
7: Mounting the Ultra RX 900 Unit:
a. Mount the Ultra RX 900 unit with the terminal block at the bottom, with the antenna hanging
straight down.
b. Connect the RELAY OUTPUT of the unit to the gate or door. A separate power supply is required
to power the door strike if used.
c.
If using with a Magnetic Lock, use the Normally Closed (N/C) connections of the Ultra RX 900.
Instructions for Existing Networks
8: Teaching the Keypad Unit into an existing Gate Network:
a. Will the Primary Access Control Unit be a Gate Access Panel (GAP)?
No: Go to step 8b.
Yes:
On the Keypad Unit, enter in the Master Pin Number, followed by
56
. Immediately
enter in the Master Pin Number on the GAP, followed by
5
.The Keypad Unit will sound a
double beep, indicating it was successfully taught. Go back to
step 5
for Mounting
Instructions and then proceed to
step 9
.
b. Will the Primary Access Control Unit be a Basic Access Unit (MiniGAP)?
No: Go to step 8c.
Yes:
On the Keypad Unit, enter in the Master Pin Number, followed by
56.
Immediately
press the learn button on the Basic Access Unit (black button located inside the unit, at the
top of the board) and release. The Keypad Unit will sound a double beep, indicating it was
successfully taught. Go back to
step 5
for Mounting Instructions and then proceed to
step
9
.
c. With a Keypad Unit as the Primary Access Control Unit
Teach the Keypad Unit according to the instructions in
step 2.
Go back to
step 5
for
Mounting Instructions and then proceed to
step 9
.
Magnetic Lock – Normally Closed (N/C) Connection
Door Strike – Normally Open (N/O) Connection
Magnetic Lock – Normally Closed (N/C) Connection
Door Strike – Normally Open (N/O) Connection
