Universal Tool a Division of Florida-Pneumatic Manufacturing Corporation
851 Jupiter Park Lane, Jupiter FL 33458
Installation
1
Cleaning the air hose
□
A 3/8" air hose is required, with a maximum length of 25 ft .
□
Clean the air hose of accumulated dust and moisture
before connecting it to the air supply .
NOTE: If a longer air hose is required, connect a 1/2" air
hose to the 3/8" air hose to ensure the die grinder has the
necessary air supply .
Ensure the air line is shut-off and drained of air before removing this tool for service or changing sockets . This will prevent the tool
from operating if the throttle is accidentally engaged .
LUBRICATION
□
An in-line filter-regulator-lubricator is recommended as it increases tool life and keeps the tool in sustained operation .
□
Regularly check and fill the in-line lubricator with air tool oil . Avoid using excessive amounts of oil .
□
Adjust the in-line lubricator by placing a sheet of paper next to the tool’s exhaust ports and holding the throttle open
approximately 30 seconds . The lubricator is properly set when a light stain of oil collects on the paper .
□
If it is necessary to store the tool for an extended period of time (overnight, weekend, etc .), generously lubricate the tool
through the air inlet . Run the tool for approximately 30 seconds to ensure the oil is evenly distributed throughout the tool .
Store the tool in a clean and dry environment .
□
Recommended lubricants: Air tool oil or any other high grade turbine oil containing moisture absorbent, rust inhibitors,
metal wetting agents, and an EP (extreme pressure) additive .
Maintenance
Recommended Air Line Set-Up
Part
Description
A
Air Tool
B
Quick Plug
C
Quick Coupler
D
Air Hose
E
In-line Regulator
F
In-line Lubricator
G
In-line Filter
H
Air Compressor
Содержание UT8707K
Страница 7: ......
