VLS Service Manual
Table of Contents
X-Axis
Page | 55
X-Axis
7. Remove the left end support by removing the four screws located on the top (2) and the bottom (2) of
the support.
8. Installation is opposite of removal.
NOTE: During reinstallation It is often easier to feed the belt through the X-Axis rail prior to installing the end
assemblies. Ensure that you do not have a twist in the belt. Failure to remove a twist will result in the laser
system not functioning correctly.
9. Once
the
X-axis Arm
has been reinstalled tension the X-axis belt as in
X-Axis Belt Replacement
.
10. To finish the installation make sure perform the
X-Axis Arm Alignment Check and Adjust (Squaring)
.
