12
CHECKING THE CODES
If you have set up the Atlas XL Universal Remote Control
using the
Searching For Your Code
procedure (on the pre-
vious page), you may need to find out which four-digit
code is operating your equipment. For example, to find
out which code is operating your TV:
1.
On the remote control, press
TV
once.
Then press and hold
SETUP
until the
TV
key blinks twice, then release
SETUP
.
2.
Enter
9
-
9
-
0
. The
TV
key will blink twice.
3.
To view the code for the first digit, press
1
once.Wait 3 seconds and count the number
of times the
TV
key blinks (e.g., 3 blinks = 3)
and write down the number in the leftmost
TV Code box (see below).
NOTE: If a code digit is “0”, the selected mode key
will not blink.
4.
Repeat step 3 three more times for the
remaining digits. Use
2
for the second digit,
3
for the third digit, and
4
for the fourth digit.
Finish writing down the code in the TV Code
boxes below.
5.
To check for other device codes, repeat steps
1 through 4, but substitute the appropriate key
(i.e.,
AUD
or
VCR
) for the (Audio or VCR)
device you are checking.Write down the
codes in the appropriate boxes below.
AUD Code
VCR Code
TV Code
Atlas XL Eng/Sp Manual 4/21/03 4:21 PM Page 12
