Rear Panel
16
Apollo 16 mkII Hardware Manual
(3) Line Inputs 1 – 16
The 16 analog inputs are accessed via dual female DB25 connectors. Each DB25 jack
carries eight balanced line-level channel inputs using standardized Tascam pinouts.
Note: See
DB25 Wiring
for connector pinouts.
The Line Inputs can be configured to use -10 dBV or +4 dBu reference levels. This
function is configured within the input channel strips in the Console application.
Apollo 16 rear panel – digital I/O
(4) Power Input
The included external power supply connects to this 4-pin locking XLR jack. Apollo 16
requires 12 volts DC power and draws approximately 55 Watts.
To eliminate risk of circuit damage, connect only the factory-supplied power supply. Use
the Power switch on the front panel to power the unit on and off.
Important:
Do not disconnect the power supply while Apollo 16 is in use, and
confirm the Power switch is in the “off” position before connecting or discon-
necting the power supply.
(5) 75 Ohm Word Clock Termination Switch
This switch provides internal 75-ohm word clock input signal termination when required.
Word clock termination is active when the switch is engaged (depressed).
Apollo 16’s termination switch should only be engaged when Apollo 16 is set to sync to
external word clock and it is the last device at the receiving end of a word clock cable.
For example, if Apollo 16 is the last “slave” unit at the end of a clock chain (when
Apollo 16’s word clock out port is not used), termination should be active.
POWER
UNIVERSAL AUDIO, INC.
MON OUT (R) 2
MON OUT (L) 1
LINE OUT 1-8
LINE IN 1-8
LINE IN 9-16
AES/EBU OUT
AES/EBU IN
PUSH
LINE OUT 9-16
10
7
6
9
4
5
1
2
3
8
