Unitronics Uni-I/O UIS-WCB1, Руководство по установке

Страница: 3 / 12

Uni-I/O™
Unitronics 3
9 Output LEDs Green / Red LEDs
10 Input LEDs Green / Red LEDs
11 Status LED Tricolor LED, Green/Red/Orange
N
OTE

Refer to the module's specification sheet for LED indications.
12 Module door Shipped covered with protective tape to prevent the door from
being scratched. Remove tape during installation.
13 Screw holes Enable panel-mounting; hole diameter: 4mm (0.15”).
About the I/O Bus Connectors
The I/O Bus connectors provide the physical and electrical connection points between
modules. The connector is shipped covered by a protective cover, protecting the connector
from debris, damage, and ESD.
The I/O Bus - Left (#4 in diagram) can be connected to either a CPU-for-Panel, a
Uni-COM™ Communication module, to another Uni-I/O™ module or to the End Unit of a
Local Expansion Kit.
The I/O Bus - Right (#6 in diagram) can be connected to another I/O module, or to the
Base Unit of the Local Expansion Kit.
Caution

If the I/O module is located last in the configuration, and nothing is to be
connected to it, do not remove its Bus Connector Cover.
Installation

Turn off system power before connecting or disconnecting any modules or devices.

Use proper precautions to prevent Electro-Static Discharge (ESD).
Installing a Uni-I/O™ Module onto a UniStream™ HMI Panel
N
OTE
The DIN-rail type structure on the back of the panel provides the physical support for
the Uni-I/O™ module.
1. Check the unit to which you will connect the Uni-I/O™ module to verify that its Bus
Connector is not covered.
If the Uni-I/O™ module is to be the last one in the configuration, do not remove the
cover of its I/O Bus Connector - Right.
2. Open the door of the Uni-
I/O™ module and hold it as
shown in the accompanying
figure.
3. Use the upper and lower
guide-tunnels (tongue &
groove) to slide the Uni-
I/O™ module into place.
4. Verify that the DIN-rail clips
located at the top and
bottom of the Uni-I/O™
module have snapped onto
the DIN-rail.