Unitek 6-099-04, Руководство по эксплуатации и обслуживанию

Страница: 51 / 88

CHAPTER 3: OPERATING INSTRUCTIONS
MICROPULL
®
IV WIRE BOND PULL TESTER
990-180 3-23
3 Load NONDEST.WKI AND DESTRUCT.WK1 into LOTUS 1-2-3 to see the format of these files.
Suggestions
1 Use the <Fl0> to terminate the MP4 program. This ensures that the MP4 is not inadvertently inhibited
by the PC. Switch the MP4 to the PRINTER MODE by releasing the switch on the rear panel.
2 If there is a problem receiving data from the MP4, use the PC-DOS utility program named
COMM.BAS. List Line 210, which reads:
210 LOCATE 21,3:COMFILE$="COM1 : : +SPEED$+","+","+BITS$+","+STP$
Change it to:
210 LOCATE 21,3:COMFILE$="COM1 : : +SPEED$+","+","+BITS$+","+STP$+"RS,DS"
Save the modified program as COMMP4 by entering SAVE "COMMP4". Run the modified program
and configure if for:
Selection 6 - Other Service
BAUD RATE 1200 -the Default Value for the MP4
NUMBER OF BITS PER CHARACTER
8
NUMBER OF STOP BITS 1
CHARACTERS ECHOED TO SCREEN (Y/N) Y
3 The second technique is to connect a serial printer to the RS-232 connector.
Program Documentation
1 Format of a ".PRN" file in the NON-DESTRUCT and DESTRUCT MODES
DESTRUCT PULL TEST
Date:
03-01-1988 17:17
Operator: M.P. PHFOUR
Part No: Al234567890
Lot No: 4-234-789
Beam Size: 100
Units: gf
SERIAL NO. TEST NO. PULL ERROR"
1 1 9.600001
1 2 9
1 3 8.600001
1 4 7