Unitek 6-099-04, Руководство по эксплуатации и обслуживанию

Страница: 23 / 88

MICROPULL
®
IV WIRE BOND PULL TESTER
990-180 2-1
CHAPTER 2
GETTING STARTED
Section I: Planning for Installation
Space Requirements
The dimensions of the MP4 are:
Width: 11.75 in. (29.85 cm)
Depth: 26 in. (66 cm)
Height: 7.60 in. (19.3 cm)
Weight: 40 lb. (18 kg)
Power Requirements
115 V ±13%, 60/50 Hz or 230 V ±13%, 60/50 Hz
Power: 20 watts
Fuses: 115 V operation: both Beam Drive Module and Control Unit use a 0.5 A (slow blow) fuse.
230 V operation: Beam Drive Module uses a 0.5 A (slow blow) fuse;
Control Unit uses a 0.25 A (slow blow) fuse.
Other Considerations
Environment should be clean, dry atmosphere, with relatively stable temperature.
Mounting should be to a surface that is rigid, free from shock and vibration, reasonably level.
Section II: Set-up
Incoming Inspection and Unpacking
Inspect all shipping containers for evidence of in-transit damage. Noted damage should be reported to the
carrier's agent immediately. Reasonable precautions have been taken to ensure the maximum protection of
this instrument during shipment. The delicate nature of this instrument, like any other extremely accurate
test equipment, makes it susceptible to shipping abuse.
Carefully unpack all containers included in the shipment. Save containers for possible re-use.
Loosen the Allen type button head screws located on the both sides of the Electronic Control Unit and on
the left side of the Pull Module. Remove both covers by lifting vertically. Inspect for damage and/or loose
connectors. Replace covers and re-tighten screws.