PRODUCT ASSEMBLY
ASSEMBLE OF BLADE AND GRILLE
Unscrew the plastic mounting nut from the front of the motor housing by rotating it anticlockwise.
Position the rear grille against the front of the motor housing with the handle uppermost, ensuing that
the locating pegs on the motor housing are engaged correctly in the holes of the rear grille.
Tighten the Rear Grille Mounting Nut clockwise. DO NOT OVERTIGHTEN IT.
Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the drive pin
that passes through the motor shaft.
Tighten the blade cap by turning it anticlockwise.
Position the front grille against the rear grille so that the holes in the rims that accept the small nut
and bolt are in line. Insert the bolt through the holes and screw on the nut. Do not fully tighten at the
stage.
Push the grille retaining clips into position ensuring that they engage correctly on the rim of the grille.
Fully tighten the small nut and bolt that passes through the rim of the grille.
ASSEMBLE OF BASE(For stand fan using)
Firstly, loosen and remove the four screws from the bars. Then cross bar A and bar B so that they
interlock.
Be sure to align the four holes in the bars with those on the flange of the Outer Tube. Secure the
flange to the bars with the four screws.
Loosen and remove the Height Adjustment Collar from the top of the Inner Tube. Slide the Base
Decorative Cap down over the assembly.
Replace the Height Adjustment Collar on top of the Inner Tube. Pull the Inner Tube out from the
Outer Tube to adjust the tube to the desired height and tighten the collar.
If necessary, slightly loosen the Set Screw by turning it anticlockwise. Slide the Switch Box down over
the Inner Tube and tighten the Set Screw. Make sure the Set Screw is tightly secured.
ASSEMBLE OF TABLE BASE(For table fan using)
Align the Fan Assembly over the Table Base and push together until secure.
Turn the Table Fan over and secure the 2 pieces together using the Table Base Screws.
ASSEMBLE OF wall mount(For wall fan using)
Before installing the Wall Mount Adapter, ensure the fan location is close enough to a wall adapter that
the fan can be plugged in.
Caution: due to the weight of this product, it is required it be mounted into a wall stud. Failure to do so,
could cause the product to fall and/or damage the wall location it is mounted in.
Place the Wall Mount Adapter against the wall and stud where you want to mount the fan.
level the Wall Mount Adapter for Asthetics.
Mark the hole locations on the wall with a pencil.
Using a 1/8 drill bit, drill the 2 holes for mounting.
line the holes on the Wall Mount Adapter to the Wall holes and insert the 2 Wall Mount Screws and
tighten Securely.
Remove the phillips head screw from the base of the Fan Assembly and insert the screw.
Insert the Wall Mount Adapter shaft into the Fan assembly.
Tighten the Thumb screw in the back of the Fan Assembly to secure fan.
OPERATION CONTROL
Be fore using t he fa n, m a ke sure t ha t it is on a fla t a nd st a ble su
rface. Damage may occur if the fan is
placed on an incline.
Inse rt
the plug directly into a standard AC socket-outlet. Be sure that the plug fits tightly into the
socket-outlet.
Se le ct t he de sire d spe e d by pre ssing but t ons 1 a nd up t o 3. Se le ct t he 0 but t on t o swit ch off
Oscilla t ion: Pre ss a nd de pre ss t he re la t iv
e oscillation knob on the housing of the motor to enable
or disable this function
