4. Move the heater smoothly on the right or left to catch steady the right rabbet
position
sketch map 3
OPERATING YOUR HEATER
1. Choose a suitable location for the heater, taking into account the safety
instructions
2. Set all the controls to OFF position and insert the plug into a grounded
socket-outlet. Make sure that the plug is fitted firmly.
3. Rotate the thermostat knob clockwise to MAX position and switch the heater on
as follows:
Switch I for low heat, switch II for medium heat and both switches together for high
heating.
Push switch one (I)
Push switch two (II)
Push switch one& two(I&II)
4. When your room temperature reaches the desired level, you can slowly rotate the
thermostat knob counter clockwise until the pilot light goes out. As soon as the
room temperature has dropped below a set value, the unit will re-work
automatically until the set temperature has been reached.
5. If you want to change the room temperature setting, rotate the thermostat knob
clockwise to raise the temperature, or counter clockwise to lower it.
6. Do not cover the panel heater at any time during operation, there’s a risk of fire if
the heater is covered.
7. Once you have finished using your heater, turn the power switch to off, and
unplug from the main supply.
CLEANING YOUR HEATER
Always un-plug the heater from the wall socket and allow it to cool down before
cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry
cloth.
Do not use any detergents or abrasives and do not allow any water to enter the
heater.
STORING YOUR HEATER
When the heater is not used for long periods of time it should be protected from
dust and stored in a clean dry place.
SPECIAL SAFETY INSTRUCTION FOR YOUR HEATER
1. For your safety this appliance is fitted with a thermal cut-out. In the event that the
product overheats for some reason, the cut-out prevents excessive temperatures on
