28.
NOTE: Should the unit overheat, this heater is
fitted with a safety with overheating device which
will switch the off automatically. (If the air vent is
blocked or if the fan function is not blowing air). If
this should happen, all you need to do this:
Disconnect the plug from the electrical socket for a
few minutes. Ensure the heater is not covered and
nothing is obstructing any of the vents. Plug the
heater back into the electrical socket and switch the
heater back ON.
HOW TO OPERATE
1.
Remove the unit from the box and take off any protective wrapping.
2.
Place the heater on a smooth level surface and least 30cm away from any obstacles.
3.
Plug your fan heater into the power supply. Make sure your power supply corresponds to
the power indicated on the rating label.
4.
Turn the thermostat knob (right) in a clockwise direction until it reaches the maximum
setting.
- Summer service (ventilation only): turn the knob to setting
- Heating at reduced power: turn the knob (right) to setting I (1000W).
- Heating at full power: turn the (right) to setting II (2000W).
- Switching off: turn the knob (left) to setting O
- To use the oscillation function press the button on the base of the unit. The appliance will
start rotating left and right.
5. When the room has reached the required temperature turn the right thermostat knob (where
included). In an anti-clockwise direction up to the point where the appliance switches off and
not beyond. The temperature fixed in this way will be automatically regulated and kept at a
constant level by the thermostat.
OVERHEATING SAFETY DEVICE
Your heater is fitted with a safety device that switches off the heater in the event of
overheating.
Should the heater stop working, turn the heater off and inspect of blockage of inlet or outlet.
Wait at least 5 minutes of the protection system to reset before attempting to restart the heater.
If the heater fails to operate the safety device switches the heater off again, return the heater to
your nearest service center for examination or repair.
CLEANING YOUR FAN HEATER
1.
Always disconnect the appliance from the main supply before cleaning.
2.
Clean the outside of the heater by wiping with damp cloth and guff with a dry cloth.
3.
Do not use Benzine or any other detergents/solvents or chemical agents to clean the
heater.
