UNITED CPC1500, Руководство по эксплуатации и техническому обслуживанию

Страница: 25 / 39

United Surface Solutions | 11901 Burke St, Santa Fe Springs, CA 90670 | info@unitedusa.com | (877) 837-4623 Page | 25
point. The distance should equal that of the existing bearings or exactly 8 inches. Torque
bearing retaining bolts to 80 ft-lbs.
10. Proceed to line #9 in Drive Component Removal in the previous section for installation
instructions.
11. Lubricate the new bearing according to the instructions given in the section Lubricating.
Turret Bearing - Replacement
1. Empty ALL barrels, insert into the cradles and latch cradle lids.
2. Turn OFF the power at the safety disconnect and lock the handle in this position.
3. Release the motor brake by pulling outward on the brake release knob shown in photo
5 -4 Motor Brake.
4. Loosen the motor adjustment nuts and move motor forwards to loosen the main drive
belt. Remove the belt from the motor pulley.
5. If replacing bearing on the Drive Side, remove all Idler Assemblies and both chains.
6. Loosen setscrews on both pillow blocks, Do Not remove the pillar block retaining bolts.
7. Remove the four (4) Turret Bearing Retaining Bolts for the bearing that is being replaced.
8. Loosen the Turret Bearing Setscrews for the bearing on the OPPOSITE side of the turret.
9. Gentle tap the center shaft, OPPOSITE the side of the bearing being replaced, moving it
inward about 3/8 of an inch. This will push the bearing that is being replaced out of its
centering grove.
10. Remove all 4 (4) Pillar Block Retaining Bolts; 2 (2) on drive side and two (2) on free side.
P
ILLOW
B
LOCK
R
ETAINING
B
OLTS
(2)
R
ETAINING
B
OLTS
(2)
P
ILLOW
B
LOCK
B
OLT
T
URRET
B
EARING
R
ETAINING
B
OLT
(4)
C
ENTER
S
HAFT