Battery Replacement
Alarm Removal
IF TAMPER RESIST FEATURE HAS BEEN ACTIVATED, REFER
TO TAMPER RESIST FEATURE DESCRIPTION ON PAGE 17 FOR
REMOVAL INSTRUCTIONS.
Remove the alarm from the mounting bracket by rotating the
alarm in the direction of the “OFF” arrow on the cover.
Battery Replacement
If any form of battery failure is detected the red LED light will
flash and the unit will "chirp" once every 60 seconds for at least
7 days. The "LOW BATTERY" voice occurs once every 15
minutes.The green LED will also be flashing twice per second.
If the red LED light flashes along with a chirp every 30
seconds, and is not followed by the voice message “LOW
BATTERY” as described above, your unit has malfunctioned
.
Call our toll free Product Support Line at 1-800-880-6788 for
instructions on how to return the unit.
BATTERY INSTALLATION AND REMOVAL
To replace or install the batteries slide the battery door in the
direction indicated on the cover of the alarm. When installing
new batteries into the carrier, make sure that the polarity
matches the markings printed on the inside of the battery
compartment, press the battery reminder finger down into the
battery compartment and install
the battery (see Figure 6).
Completely slide the battery
door to the closed position. A
missing or improperly installed
battery will prevent the battery
door from closing and result in
improper alarm operation.
SLIDE
OPEN
INSERT
FIGURE 6
Battery
finger
18
2553-7201-04(KN-COSM-BA).qxd:_ 2017.9.26 11:27 AM Page 20
