- 9 -
To store a pager number and numeric code
1. With the dialer at the “PROGRAM: NUMBERS” prompt, press “1” (YES).
2. Enter all the digits of the pager number to be dialed. Check the LCD to insure the correct numbers
are pressed.
3. After inputting the entire pager number (1 + area code if needed), press the PROGRAM/PAUSE
(“P”) button and hold it down for about 2 seconds. A “P” will appear in the LCD following the
number. If more pauses are required, simply repeat the process by releasing the “P” button and
pressing it again for 2 seconds. Up to 10 pauses are allowed.
4. After the pause sequence, input the numeric code to be delivered. This is the code that will be
displayed on the pager. (Note: Some pager services require a “#” sign at the end of the numeric
message for proper transmission. Also make sure that the total length of the number including
pauses and “#” does not exceed 28 characters).
5. Finally, press the PROGRAM/PAUSE (“P”) button (momentarily), then the “1” key. This will
store the number, pauses and the numeric code in location 1.
6. Repeat step 1, then press all the digits for the second pager number to be dialed. Check the LCD,
input pause(s), input the numeric code, then press the PROGRAM/PAUSE (“P”) button
(momentarily) and the “2” key. This will store the number in location 2.
7. Repeat the process, if needed, for locations 3 and 4.
8. You may store pager number and numeric code in any memory location (1-4).
9. When testing the pager operation, it is recommended that the AVD-45b be in the “OPERATE”
mode, connected to a phone line and the input triggered.
NOTE: A pause counts as one digit. Up to 10 pauses are allowed.
PROGRAMMING THE DIALER
