- 28 -
• Place the Strip Cut Shredder attachment onto
a suitable container:
First place the broad end of the appliance on the
edge of the container. Then pull the telescope
arm
4
out sufficiently to ensure that this also
sits securely on the edge of the container.
• Insert the plug into a mains power socket.
Operation
You can shred up to 6 sheets (80g/m
2
paper)
at the same time.
Attention:
Remove all staples and paper clips before feeding
paper into the cutter opening
2
. Otherwise the ap-
pliance could be damaged.
Switching the appliance into the Auto mode:
• Place the switch
1
for shredding into the position
"AUTO". The motor starts automatically and swit-
ches itself off automatically if no further paper is
in-serted.
Take note:
Always guide smaller papers into
the middle of the cutter opening
2
. The contact
which starts the cutting process is located there.
Clearing a material blockage:
• Slide the switch
1
into the position "REV"
(Re-verse = reverse) should the paper to be
shredded jam.
The appliance now goes into reverse and the
paper to be shredded is returned.
• Pull the paper to be shredded out of the applian-
ce and then place the switch
1
at "AUTO".
• The appliance is now once again ready for ope-
ration.
Switching the appliance off:
• To switch the device off, slide the switch
1
into
the "OFF" position.
• If you do not intend to use the device for a long
period, disconnect the plug from the mains power
supply.
Notice regarding overheating of the appliance:
If it overheats, the appliance switches off automati-
cally.
Attention:
Remove the plug from the mains power socket to
avoid an unintended starting of the appliance.
• Empty the container.
• Allow the appliance to cool down.
• Re-insert the plug into the mains power socket.
• Switch the appliance on, in that the switch
1
is
placed into the position "AUTO".
Cleaning
Danger!
Always remove the power plug before cleaning the
appliance. There is a risk of receiving an electric
shock!
Warning!
The cutters in the appliance are very sharp! Injury
hazard!
Attention:
Do not spray oil or any other lubricants into the cut-
ter opening
2
. These would irreparably damage
the appliance!
IB_96717_UAV190A1_LB1 20.02.2014 8:16 Uhr Seite 28
