24
8. Re-Set Wi-Fi Board
If the Grizzl-E Smart Charger has lost connection and is unable to re-establish the connection
try resetting the board using the following procedure:
1. Unplug the Charging Station.
2. Remove the front cover by removing the 4 screws at each corner of the charging station.
For more information on how to remove the front cover refer to Chapter 3.1 Adjust
Maximum Current Output on page 10.
3. With the front cover placed to the side, locate the DIP switch on the charging station circuit
board. The DIP switch is a 4-position switch on the main circuit board, located directly to
the left of the LED.
4. Using a non-conductive object move the Left Switch to the down position. This applies for
all amperage settings.
5. Plug the Charger back in. Wait 30 seconds. Ensure the indicator light is Blue/Purple
alternating with 1 second frequency.
6. Unplug the Charger again.
7. Set the DIP switches back to the original position.
8. Plug the charger in. Charger will display Blue/Purple alternating indicator light.
9. Follow the instructions from Chapter 7. Set Up Smart Functionality on page 20 to
reconnect to your Wi-Fi network and OCPP Network.
10. Replace the enclosure lid by tightening the 4 screws at each corner.
