Code 39 M
Codabar N
Code 93 L
Code 128 K
UCC/EAN128 ]C1
MSI O
Code 32 T
Delta Code D
Pressey Code P
Label Code IV, V B
China Postal Code C
Track I None
Track II None
Track III None
2.6. Scanning Mode
For CCD or Laser scanners, the keyboard provides the following seven scanning
modes:
* Trigger Mode:
When the trigger is pressed, the keyboard will power up the CCD or laser
scanner to read the bar code. If the bar code is decoded, the Keyboard will turn
off the scanner and upload the data. The Keyboard will turn off the scanner if
the label cannot be read within approximately 3 seconds.
To read the next label, release and press the trigger again.
* Flash Mode:
When Flash Mode is enabled, the keyboard causes the photo LEDs of the CCD
to strobe until it detects a label. When a bar code is detected and read, the
keyboard uploads the data and attempts to read the next bar code during the next
5 seconds. If no bar code is read during that period, the photo LEDs begin to
strobe again.
In Flash Mode, the keyboard is designed to not double-read the same barcode.
In order to deliberately re-read the same barcode, the barcode must be removed
from the scanner’s readable area for at least one second.
Pressing and releasing the trigger will stop the flashing and turn off the photo
LEDs. Pressing and releasing the trigger again will resume the flashing.
Note:
The flash function is for CCD scanners only. It cannot support Wand or laser
scanners. Set the keyboard to Switch Mode in order to operate the scanner.
* Multiscan:
When Multiscan is enabled, pressing the trigger enables the scanner to read
