Unitec MABASIC 200, Руководство по эксплуатации

Страница: 9 / 54

1 1 M AB a s i c 2 0 0 , 4 0 0 , 4 5 0 , 8 5 0
ENGLISH
W AR NING
► Check for secure clamping of the
electromagnets on the substrate before
every use (see Preparation section).
► Secure the machine with the safety
lashing strap supplied when working
from an inclined or vertical position or
during overhead work. The machine
could fall down if the magnet is
loosened or the power fails.
► Check that the tool is tightened
securely before using (see Inserting
the tool section).
► Do not allow the connecting cable to
hang over edges (trip wire effect).
Pr e v e n t i n g d a m a g e
ATTENTION
Po t e n t i a l d a m a g e t o p r o p e r t y i f t h e
m a c h i n e i s i m p r o p e r l y u s e d !
Observe the following instructions to avoid
property to damage:
► Before connecting the machine,
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. The
data must correspond in order to avoid
damage to the machine.
► Always use the handle to carry the
machine and not the connecting cable.
► Do not pull the mains cable to remove
the plug from the mains socket.
ATTENTION
► Do not crush the connecting cable.
► Do not expose the connecting cable to
heat or chemical liquids.
► Do not pull the connecting cable
across sharp edges or hot surfaces.
► Lay the connecting cable in such a way
that it cannot be caught and wound up
in the rotating part of the machine.
Sa f e t y a p p l i a n c e s
R e s t a r t p r o t e c t i o n
NOTE
► The machine stops automatically when
the magnetic clamp is switched off or if
the power supply is interrupted.
In order to prevent the machine from starting
unexpectedly after switching on the magnetic
clamp again or after reconnection following
interruption to the power supply ("restart
protection"), the machine must be switched
on using the ON/OFF switch.
Sy m b o l s o n t h e m a c h i n e
The symbols on the machine have the
following meaning:
Sy m b o l M e a n i n g
Electric shock hazard!
Read the operating instructions
before beginning work!
Wear protective goggles and ear
protection!
Sa f e t y