![background image](http://html1.mh-extra.com/html/unitec/mab-525/mab-525_operating-instructions-manual_3984647024.webp)
2 4
Op e r a t i o n
M AB 5 2 5
ENGLISH
D r i l l i n g w i t h c o r e d r i l l s
Proceed as follows when drilling with core drills:
Install the quick-change drill chuck system (A) and connect
up the cooling lubricant system .
Install the appropriate ejector pin in the core drill and insert
the core drill into the quick-change drill chuck system (A) .
Position the machine at the working location, align it and
switch on the magnetic clamps .
Select the appropriate speed and switch on the machine .
NOTE
Observe the following instructions when drilling with core drills:
►
Drilling with core drills requires no great effort . The drilling
process is not accelerated by higher pressure . The drill
wears faster and the machine can be overloaded .
►
Use the cooling lubricant system installed on the machine
with high-performance cutting oil from CS Unitec .
►
The cooling lubricant system cannot be used when working
overhead . In this case use the high-performance grease
spray ZHS 400 . Spray the drill on the inside and outside
before drilling . Repeat this procedure when drilling deeper
holes .
►
Pay attention to a regular chip discharge . With larger drilling
depths, break the chip .