H y d r a u l i c
R o t a r y H a m m e r D r i l l
2 2 4 2 6 0 0 1 0
Translation of the original manual,
compiled: 24.02.17
224260010_BA_en_Version_CSU_00
Page 6 of 18
Startup
Hammer drilling
Fig. 3.1: Pull back the adjusting sleeve and lock it in clockwise direction.
Fig. 3.1
Fig. 3.2
Fig. 3.2: Pull back the sliding sleeve and insert the drill. Turn until the sliding sleeve returns into the initial
position. Press the machine against the work surface before switching it on, otherwise the tool will not
hammer. If the drill sticks in the hole, withdraw and reinsert it several times when drilling.
Do not exert undue pressure on the machine - this will not increase its performance. Just position the bit and
guide it into the hole. For hammer drilling do not use any quick-release chuck. (see fig. 3.4 and 3.5).
Fig. 3.3: When starting to drill in brittle material (tiles, etc.): Unlock the adjusting sleeve. Hold and continue to
drill the hole, then switch off the machine briefly and relock the adjusting sleeve.
Fig. 3.3
Fig. 3.4
CS Unitec, Inc.
• Toll-free: 800-700-5919 • Ph: 1-203-853-9522 • Email: [email protected] •
www.csunitec.com
