ANTI-DRIP SYSTEM
This system protects the iron and the things you iron from getting spoilt. No drops of water come out
of the Soleplate (1). The iron gets warm faster.
ANTI-CALC SYSTEM
The iron with build-in permanent Anti-Calc System to reduce deposit of scale and maintain longer life.
SELF-CLEANING
1. It is important to apply "Self-Clean" at the first time of using the iron then at least once per month
to remove scale etc.
2. Fill the water up to "MAX" line in the Water Tank (3).
3. Insert the plug into the wall socket.
4. Set the Temperature Control Button (14) to “MAX”.
5. Allow the iron to heat up until the heating light goes off and then come once again.
6. Remove the plug from the wall socket.
7. Keep the iron horizontally over the sink.
8. Turn the Steam Control Button (8) to position “
” then press down / hold the Self-Clean Button
(15).
CARE AND STORAGE
•
Check that the voltage on the iron rating plate coincides with mains voltage at your home.
•
The iron shall not be used if there are visible signs of damage or if the iron is leaking. The iron shall
be sent to the manufacturer or his qualified service agent before further use.
•
Completely unwind the main cable.
•
Always unplug the iron when not in use, even if only for a short period of time. Unplug it from the
mains and leave it standing on its rear base.
•
Always unplug the iron before filling the water or when removing the excess water from it.
•
Never immerse the iron in water.
•
The iron shall be used on a stable ironing board.
•
The iron must be used and rested on a stable surface.
•
When placing the iron on its stand, ensure that the surface on which the stand is placed is stable.
•
Avoid ironing over zippers, rivets on jeans, etc., as they will scratch the Soleplate (1). Iron around
them instead. Keep the iron Soleplate (1) smooth.
ENGLISH
6
Burst of steam feature does not
work.
Spray Nozzle (4) does not work.
The iron is leaking.
There is no water in the Water
Tank (3). The iron is cold, let it
warm up.
There is no water in the Water
Tank (3).
The iron is cold, let it warm up.
The Water Tank (3) must be at
least 1/4 full. Temperature must
be set to steam position. The iron
should be in the horizontal
position. Prime pump briefly.
Allow a short pause between
shots. Be sure to fully depress
the Steam Button (9).
The Water Tank (3) must be at
least 1/4 full. Fill the iron as
described in the section “How to
fill the Water Tank (3)”.
The variable steam dial must be
set on, until the iron is hot. The
temperature setting is too low to
produce steam. Shot of steam
used too much, allow the iron to
re-heat.
USI-43 Instr 3/26/09 4:07 PM Page 6