Unit USI-281, Инструкция по эксплуатации

Страница: 4 / 10

Cleaning and maintenance.
After use.
1. Disconnect power supply and empty the water left in water tank.
2. Wait for the sole completely cool before you remove the iron.
3. Wipe the iron soft, damp cloth. Do not use solvents to clean the soleplate and abrasive cleaners.
4.
Store the iron in an upright position. Avoid scratching the sole.
Self-clean function.
It is necessary to regularly clean the iron, depending on the water hardness and intensity of use.
1. Fill water into the water tank and set the temperature selector to Max position
2.
Connect the iron to the network. Make sure the steam regulator is set to “Off”.
Warning: Never pour vinegar or other liquid cleaners for eliminating calcium into water tank!
3. As soon as the iron heats up, and the light indicator goes out, hold the iron over the sink, press and hold
self-cleaning (12). The steam and boiling water will come out through the holes in the sole of washing
away scale and impurities.
4. Release the button self-cleaning as soon as the water in the tank is over.
Auto-decalcification function
Iron equipped system Auto-decalcification (Anti-Calc). Thanks to it, reduces the rate of scale formation.
Faults-reasons and solutions
Iron emits an odor or smoke
Iron gives off an odor when turned on for the first time. Oils used during manufacture need to be burnt off allow ten
minutes for odor to disappear.
Iron does not heat
The iron should be plugged into 220-240 V, AC electrical outlet only. The temperature dial must be set at the
desired temperature.
Iron does not steam
The water tank many be empty. Turn the steam valve to “0” and add water. Allow the iron to heat, and then set the
steam dial to the steam setting.
Burst of steam feature does not work
The water tank must be at least 1/4 full .Temperature must be set to steam position. Iron should be in the horizontal
position. Allow a short pause between shots. Be sure to fully depress the burst of steam button.
Spry mist feature does not work
The water tank must be at least 1/4 full. Fill the iron as described in the section “Filling the water tank”.
Iron is leaking
The steam switch should be set to the appropriate position. The heating controller should be in minimum position.