Unit USI-281, Инструкция по эксплуатации

Страница: 3 / 10

5. Turn the temperature regulator by comparing its value with a dash in front of it:
·
position for nylon and rayon
· ·
position for wool, silk and mixed fabrics
· · ·
position for cotton or linen (steaming)
Filling the water tank
1. Unplug the iron.
2. Set the mode switch steam to "off".
3. Fill the tank through the opening for pouring water.
4. After completion of the work always drain the remaining water from the tank. Do not store the iron with
remaining in the tank water.
Important: If you have hard water, we recommend that you use distilled or demineralized water.
Do not use solvents or perfume water.
Steam ironing
1. Fill the tank with water as described in "Filling the water tank."
2. Connect the iron to the electrical grid.
3. Steam ironing is possible only when the maximum heating temperature of the sole. Otherwise, no
formation of steam and the water can flow through the sole.
4. Wait until the indicator light turns off, it indicates that there has been a selected temperature.
5. Set the steam supply to the desired position.
6. At the end of the work and during breaks in ironing things set the iron in vertical position.
7. After completing unplug the iron, pour the remaining water in it, and put to cool.
Spray
1. The spray can be used in any position, either in dry or steam ironing, as long as the water tank is filled
with water.
2. Press the spray button for this function.
NOTE: This button has to be pressed repetitively to start this function for the first time.
Shot of steam
Shot of steam give extra steam for removing persistent wrinkles.
1. Place the temperature selector at the “max” position and wait until the pilot light goes out
2. Wait for a few seconds for the steam to penetrate the fibre before pressing again.
NOTE: For the best steam quality, do not use more than three successive bursts each time. Several pumping
actions are needed to start this function.
Excessive use of this feature will cause the iron to cool, ensure that the pilot light is out, before
operating the shot of steam control