UNISEM UniTracer L-100, Руководство пользователя

Страница: 9 / 42

www.unisem.co.kr | iot@unisem.co.kr | +82.31.724.2548
3) Device retrieve method
- Hold the eSeal device with the magnet attached to the container with both hands firmly and
remove it safely.
- Retrieve the device with opened wire device.
2. How to use the device
2.1 Device operating process
1) When the wire is tightened, the NFC card authentication is performed first.
- The LED of the NFC antenna flashes together with a beep for 5 seconds.
- The registered NFC card should be touched to the NFC tag within 5 seconds.
- If the NFC card is authenticated, the alarm is stopped and the LED flashes.
※ In order to use NFC card, NFC card ID must be registered in L-100 device.
(Refer to '3.5 APN and NFC setting method’.)
2) When the NFC card authentication is completed, GPS is received. (Takes up to 180 seconds)
- At this time, the Operation switch flashes green.
- When the GPS reception is complete, the green light turns off.
3)
Once the GPS reception is complete, access the communication network. (Up to 300 seconds).
- At this time, the Operation switch flashes blue.
- When the device is connected to the network and the data transmission is finished, the
blue light turns off.
4) After the Operation switch light is blinking, the device waits until the next operation.