OPERATING MANUAL FOR
KENTUCKY HOT
5
3
BEFORE FIRST TURN-ON
3.1
Place of operation
1) The showcase will work correctly:
- At the workplace with temperature from +16°C to +25 °C
- With ambient humidity max. to 60% RH
2) Do not operate the showcase:
- near the cooling nor heating sources
- in the place where sunlight can affect operation of the unit
- in the place with draught (from air-conditioner or near the entry)
- near other objects which could prevent proper ventilation
3.2
Assembling
Before assembling consider whether the unit is going to be placed on the table or droped in the table. Model Thaya allows the
installation into the furniture by removing the front bottom panel. It is necessary to keep correct dimensions when you install
the unit as drop-in.
How to drop a showcase in table and what rules need to be met can be found in attachment “Installation into the table” at
the end of this manual, page 13. If the information is missing or the guide is unclear, contact your supplier.
1) Showcase should be aligned to the horizontal position by using the adjustable feets on the bottom of the display case.
Align the showcase by turning the adjustable feet with wrench nr. 24. into horizontal position. After the establishment,
secure the position of the feets by tightening the nut wrench nr. 17.
2) Insert shelf consoles.
3) Insert grids to shelves.
4) If the model is provided with sliding back doors, insert them.
3.3
Connection to the electric power
The case is designed for single-phase voltage 230V / 50 Hz. The power supply socket must be separately grounded and
protected by a fuse of 10A. Other devices must not be attached to this separately fused circuit. It is necessary that the
electrical connections of this showcase is protected and it complies with applicable regulations.
3.4
Before first turn-on
1) Visualy check if all packing materials and protective foil were removed.
2) Clean the exhibition space, containers and shelves with a slightly damp cloth and a suitable detergent.
3) Dry the surface of washed surfaces with a dry cloth.
4) The tray located at the rear portion of the case bottom, see chapter 2.3, position 4, should be loaded by approx. 3
liters of hot (50-60°C) water BEFORE start. The water evaporates during operation and moistens the inner space of
case (mitigates drying on display).
Check the water level in the tank periodicaly to avoid its complete evaporation. The schowcase can NOT be
used WITHOUT WATER!
5) Heat the interior properly, see chapter 5.2 Turn on.
